Polyvine Wood Dye 500ml

Timber surfaces to be treated should be clean, thoroughly dry and free from dust, dirt, grease, oil or any other surface contaminants. Ensure to remove any oils from oily hardwoods and any resins from resinous softwood.

Bare or New Timber

1. Lightly sand new or bare timber to provide a key, removing any sanding dust
2. Wipe the surface down with a lint-free cloth dampened with methylated spirit
3. Remove any mould or algae growth with a dedicated cleaner
4. Fill any gaps or minor imperfections in the wood surface with a suitable Wood Filler
5. If the timber is not pressure treated, apply an appropriate wood preservative treatment

Previously Treated Timber

1. Any old coatings must be removed by sanding back to bare wood or using a dedicated wood stripper
2. Then treat as ‘New Timber’ above

Always do a test area before starting any project to asses product suitability and final finish. Follow the manufacturer’s instructions on the tin at all times. Do not apply to exterior wood when rain is imminent. Do not apply at temperatures below 5°C.

1. Stir thoroughly (do not shake) before and periodically during use to ensure a consistent finish
2. Use a suitable container to mix colours in, if needed
3. Apply a liberal, even coat, working the dye along the grain of the wood where possible
4. For best results, use a good quality synthetic bristle brush or cotton cloth, wiping off any excess, to give a uniform finish
5. This product may be applied directly as supplied or diluted with water to create a less intense colour or shade
6. Apply a second coat if a deeper shade is required, allowing 4 hours between coats
7. Allow to fully dry between 1 – 2 hours

Cleaning Equipment

Application equipment can be cleaned using soap and water. Once cleaned, allow to dry naturally.

For added protection, it is advised to overcoat Polyvine Wood Dye 500ml with a suitable top coat, such as Polyvine Heavy Duty Interior Wood Varnish, Polyvine Heavy Duty Floor Varnish or Polyvine Exterior Wood Varnish.